 | |||||
| It was pretty cold in the shop; a good argument for pre-heating your oven! |
 |
| I couldn't photograph the oven to quench process (only one set of hands). After quench, cryo, and temper check to make sure everything happened correctly |
 |
| Just what I was looking for; 60.5 HRC |
 |
| You can see I already started final grinding; remove the oxides and correct any grind issues. |
 |
| A little hand sanding plunge line to tip to erase what is left of the spine to edge marks from the grinder. |
 |
| Custom sanding blocks. |
 |
| 15 micron, 2000 and 2500 goes pretty fast. |
 |
| If you did everything right you end up with these results. |
No comments:
Post a Comment